Cannon Indoor Furnishings LC100 User Manual

Limited Lifetime Warranty  
Troubleshooting  
Specifications  
Light Cannon 100  
HID Dive Light  
Power: 25 (equivalent), 12.5 (actual) watts  
Lamp: HID Metal Halide  
Lamp Life: 500 hours  
Light does not come on after loading batteries  
Make sure batteries are oriented in the right direction.  
Make sure lamp is pushed all the way into the socket.  
If lamp module is extremely hot, wait for it to cool down while the  
thermostat resets. Then, turn it on again.  
UK International products are engineered for maximum performance and  
durability. All products carry a Limited Lifetime Warranty to the original  
retail purchaser to be free from defective material and workmanship under  
normal and intended use. In addition, the UK International Limited  
Warranty covers materials used in its products to the original purchaser,  
from the date of purchase, as follows: plastics for 10 years; fabrics and  
rubber for 3 years; rechargeable batteries for 90 days; and lamps for 30  
days (batteries and lamps are not manufactured by UK International).  
In the event the original retail purchaser detects a defect in the material  
or workmanship, the product along with proof of purchase date should be  
returned to an authorized UK International dealer or directly to UK  
International with the postage prepaid. UK International agrees to repair  
or replace at UK International' sole discretion any product found to be  
defective in material or workmanship within the time period specified  
above. For the complete Limited Lifetime Warranty write to UK  
International.  
Color Temperature: 6000 degrees Kelvin  
Luminous Flux: 450 lumens  
Replace fuse.  
Burn Time: 3-4 hours (alkaline batteries)  
2.2 hours (optional UK nicad pack)  
Charge Time: 10-12 hours with optional UK Nicad Pack  
Voltage: 10 volts  
Make sure bottom contact plate is oriented properly.  
Lamp is broken. (LC100 makes a faint ticking sound for a few  
seconds when switch is turned on, but light does not ignite)  
Light does not come on immediately; takes time to get to full brightness  
This is normal. The light takes 20-30 seconds for full brightness  
when it is cold. It will take less time when it is warmed up.  
Current: 1.25 amps  
Utilizing the latest  
HID lighting technology,  
the Light Cannon 100  
emits a beam of light as  
white as the Sun and  
penetrates water farther  
than any conventional  
halogen or xenon  
Battery: 8 x Alkaline C-cell, UK Nicad Pack,  
8 x Nicad batteries, 8 x NiMH batteries  
Restart time: 3 seconds  
Switch will not rotate  
Pull safety lock outward (see diagram on opposite side)  
Light goes out and will not come on again  
Beam width: 6 degrees  
You might have accidentally turned the light off. Make sure switch is  
in OFF position (clockwise rotated). Wait at least 3 seconds before  
turning light on again.  
Light flickers and changes color  
This is normal when the batteries are nearly drained.  
Replace batteries.  
Light changes color slightly when pointing  
at different angles up and down  
This is normal. The light may change color slightly depending  
on the angle of the light.  
(optional video wide angle filter included)  
Safety Features: Thermostat shutdown for overheating, fuse  
protected, polarized battery chamber,  
isolated electronics.  
Fuse: AGA-2 (Spare included)  
Maximum Depth: 500 feet water  
Grip: Pistol or Lantern style  
Address all correspondence and returns to:  
dive light.  
UK International  
13400 Danielson Street  
Poway, CA 92064  
Materials: Tough, non-corroding ABS, TPE  
and polycarbonate plastic  
Light leaked, filled with water  
Size: 3.2 dia x 8.2 inch  
Weight: 2.5 lbs  
Open light immediately, remove batteries, rinse with fresh  
water, let components dry, remove main o-ring, reassemble  
and return to UK for service or replacement.  
Instructions  
PN Z420207 rev 7/10/06  
Light Cannon 100 Instructions  
Nicad Charging  
! CAUTION  
Plug charger into wall socket and cord into  
Batteries which are (1) loaded without  
observing the proper polarity, (2) not the  
same type, brand name and age or (3)  
completely discharged can vent hydrogen  
gas and possibly cause an explosion.  
Load batteries according to the diagram  
shown on the light or in these instructions.  
Do not mix batteries of different type,  
brand name or age.  
socket located on end of battery. Charge 10-12  
hours or until the battery begins to feel warm.  
stored for several months will need to be charged and discharged several  
time for maximum burn time to return.  
Switch  
Pull the switch lock outward as shown. Rotate the switch counterclock-  
wise to turn the light on. It will take approximately 20 seconds for the light to  
come to full brightness. Rotate the switch clockwise to turn the light off. You  
must wait at least 3 seconds before turning the light back on again or it will  
not light. Push the switch lock inward when the light is off in order to pre-  
vent accidental activation. NOTE: Turning the light ON and OFF often will  
shorten the life of the lamp slightly. It is better to leave the Light Cannon 100  
ON than to switch it ON and OFF repeatidly during a dive.  
Thank You  
Thank you for purchasing the Light Cannon 100. It is a major advance-  
ment in hand held lighting. Unlike standard flashlights, the lamp does not  
use a glowing filament of tungsten for the light source. Instead, light is  
emitted from a very small glowing ball of ionized gas. As a result you will  
get 3 times as much light from a set of batteries and the light will be much  
whiter enabling it to travel farther underwater.  
Observe  
Alignment  
Arrows  
Case  
Optional Recharteable  
Nicad Battery Pack  
Discard all batteries as soon as they are  
drained or no longer produce light.  
Handle Insertion  
Contact  
Plate  
Observe  
alignment  
arrows on  
battery and  
inside case  
Slide the handle into the dovetail groove next to the switch. Tighten the  
screw located inside the pistol grip or at the base to the lantern grip. Test  
the handle to make sure that it will not slide out of the groove.  
! CAUTION  
Switch  
Lantern Grip  
Pistol Grip  
Reflector and Lamp Module can be  
extremely hot after use. Can cause burns  
Main O-ring  
O-ring Care  
Loading Batteries  
Each time the case is closed, make sure that the Main O-ring is clean and  
the sealing surfaces it touches are clean and free from scratches. Lightly  
grease the O-ring with silicone grease, place it on the case and screw the  
bezel down tightly to compress the O-ring.  
Load 8 alkaline C-cell batteries into the light as shown in the diagram.  
When inserting the contact plate be sure to observe the alignment  
arrows. Make sure the + and - contacts of the batteries match the + and -  
marked in the light. If any cell is loaded backwards, the light will not turn  
on. Insert the lamp module and reflector. Make sure the O-ring is clean.  
Screw on the bezel until it is tight and compresses the O-ring.  
Push In to Lock  
Pull Out to Unlock  
! CAUTION  
Lamp Module  
HIGH VOLTAGE  
Do not open reflector module when con-  
nected to batteries or power supply.  
Switch Operation  
Fuse Replacement  
ON rotate CCW  
OFF rotate CW  
8 Alkaline C-Cell Batteries  
AGA-2 fuse  
located under plate  
Remove the Reflector and Lamp Module from the Light Cannon case.  
Unscrew the two screws from the rear plate on the Lamp Module. Remove  
the fuse from the socket. If the filament in the fuse appears broken or the  
glass is blackened the fuse is burned out and should be replaced with the  
spare AGA-2 fuse stored in the Lamp Module. New fuses are available at  
hardware and auto parts stores. Insert the replacement fuse in the socket,  
replace the rear plate using the two screws.  
FRAGILE LAMP  
Handle With Care!  
Reflector  
Rechargeable Batteries and UK Rechargeable Nicad Pack  
Dropping the LC100 onto a  
hard surface may break the  
lamp or knock it loose from its  
socket. If the light is dropped  
push the lamp back into the  
socket to reduce the chance of  
breakage if the light is dropped  
again.  
In addition to disposable alkaline batteries the LC-100 can also be pow-  
ered by the UK Rechargeable Nicad Pack or 8 individual C-size recharge-  
able nicad or NiMH cells.  
Wide Angle Filters  
Align rib on lamp  
base with slot in  
socket  
When using the UK Rechargeable Nicad Pack, the spring contact plate  
should be removed from the case. Use the spring supplied with the Nicad  
Pack. The rechargeable battery pack is charged by inserting the charge  
plug from the charger into the socket on the end of the battery pack.  
Charge the pack 10-12 hours or until the pack begins to feel warm. For  
maximum burn time charge the pack immediately before use. It is not nec-  
essary to completely discharge the battery pack before recharging. Less  
time will be required to charge a partially discharged pack. A battery pack  
Lamp Replacement  
Wait until the lamp is cool in the Lamp Module. Remove  
the reflector. Pull the glass tube straight out. Insert the new  
lamp into the lamp module so that (1) the two pins at the base  
of the lamp line up with the holes in the lamp socket, and (2)  
the rib on the side of lamp base lines up with the slot in the  
socket. Push lamp gently into the socket. Insertion of the lamp  
in reverse will severely shorten the life.  
Wide Angle Video Filter  
The LC100 can be used as a video light. For wide smooth illumination open  
the LC100 and insert one or two Wide Angle Filter disks in front of the reflec-  
tor (as shown in drawing) before replacing the Bezel. Each filter makes the  
beam wider to match the coverage of a medium wide angle lens. The color  
temperature of the light will be similar to daylight.  
It is best to ship the LC100  
with batteries in the light.  
When shipping the LC100 with-  
out batteries, remove the Lamp  
Module and pack it separately  
in a padded container.  
Bezel  
 

Blodgett Oven B 142G User Manual
Blue Rhino Charcoal Grill CBT726M User Manual
Briggs Stratton Automobile Parts 20M114 0138 E1 User Manual
Bushnell Camera Accessories 20 5105 User Manual
Canon All in One Printer 4509B061 User Manual
Canon Camcorder 380EX User Manual
Carson Car Amplifier SA 365 10 User Manual
Casio Digital Camera EX P505 User Manual
Casio Printer KL 7200 User Manual
CFM Corporation Outdoor Fireplace ODSHR42 User Manual